OZMA Vertical Shredders are mainly applied in applications processing pre-shredded metal scrap from twin shaft shredding systems.  These machines aggressively size reduce and densify pre-shredded material whilst liberating the various different fractions and allowing for better separations and reduced transport costs,  The breakers in the upper part of the chamber smash the material until it is small enough to enter the gap between the milling rings and chamber liners.  When the material enters the second stage the milling rings impact, grind and roll the material into clean fragments. When milled in to small enough pieces, the balled up material falls into the lower chamber.  It is then ejected by the discharge paddle. The three above stages crate a product which is both clean and of high bulk density suitable for transportation.

Typical Applications Include:

 ·  Electronic Scrap – WEEE Directive Materials
 ·  Aluminum – Castings, Profiles, UBC's etc.
 ·  Scrap Steel – Pre-shredded steel sheets, metal drums etc.
 ·  ELV's (End of Life Vehicles) – Pre-shredded vehicle bodies
 ·  SLF (Shredder Light Fraction), ASR (Auto Shredder Residue)

Standard Features 

 ·  Strong welded construction from heavy gauge, wear resistance steel plate.
 ·  Integral, annealed and CNC bored two piece chamber for quick access and simplified maintenance.
 ·  Durable, wear resistant, replaceable breakers, milling rings and chamber liners
 ·  Oversized, spherical rotor bearings with advanced seal protection – prevents bearing damage due to product migration
 ·  Adjustable product size control
 ·  Replaceable wear plates in the chamber
 ·  Stand Alone Electrical Control Panel - using quality Schneider (Telemecanique) components and Siemens PLC's
 ·  Tested, Approved and Certified to the applicable CE safety standards